Check this out. I first heard about Defense Distributed from Danger Room and this group is totally dedicated to the concept of democratized weapons manufacturing. This goes along with my prior posts about the concept of Opensource Military Hardware.

This concept is also a threat to the major weapons manufacturers out there–hence why the company they leased their 3D printer from ultimately chose to take it back. Who knows, and both sides of this issue are presented in the posts at Danger Room.

The other thing that perked me up was the use of crowd funding in order to get this going. They used Indiegogo as a funding tool for this project in order to raise the $20,000 to get it started. Below I have posted the group’s goals and here is a link to their website. –Matt

 

1) Create the world’s first 100% 3D printable gun
GOAL: Develop a fully printable 3D gun
Our initial Wiki Weapon (A) design has no moving parts and relies on a separate, inserted solenoid to fire. We begin with this design to learn from the ABS material itself, but this is a method of trial and error. At $5 per cubic inch, we are at the point where we need outside funds to produce and complete a proof gun. The result of the lessons we learn from WikiWep A will instruct the design and development of Wiki Weapon B, a fully-printable gun comprised of near 100% printable parts.
2) Adapt the design down to cheaper 3D printers
Goal: Adapt the design so it can be printed on less expensive 3D printers-without compromising safety.
These guns will be almost completely plastic, so melting and failing in your hand will be a concern. Only after testing a few dozen designs to failure will we discover the right limitations to be comfortable rating a WikiWep as safe for one use. Basically we need to break some guns. This is the seed money for the second phase of development. We want to minimize negative media about the safety concerns of untested firearms and the inevitable suggestions that governments should protect us from ourselves.
3) Become The Web’s Printable Gun Wiki Redoubt
Goal: Further embrace the “Wiki” root of the project and establish a printable gunsmithing commons.
Instead of hacking off central planners directly, why not ignore them into irrelevance? In response to our project’s feedback and instincts, we open up this site to the world to share and participate in the creation and distribution of knowledge relevant to advancing 3D printable weapons.